Final bolt and one back home

Uncategorized

Had to cut the final bolt off to free the hanger from the leaf sprint. Nothing else would shift it.

Then a surprise as the Golf was ready. Collected it and runs well. Same key though and the TOAD alarm is definitely not active.

He thought it ran really well too – so that’s good.

Then evening run in the Aero.

Just hitting it harder

Uncategorized

Ground off the top of the bolt. First with the Dremel delicately, then with the angle grinder less so.

Bloody bolt would still not move and I was at it for an hour. So I decided to hit it from behind again. A few goes and I went back to grinding … but what was that ? The washer was free ? That means the bot moved a fraction of an inch. 
So I went back and hit it again and again and again, now with both hands on the club hammer. 
It moved !
Thump, thump, thump and it was out.
I guess the grinding had warmed up the bush and the thumping had broken it free. Whoop !
Next is to get the hangers off.

Oh and the TOAD alarm fob is not obtainable.

Gerrting their and getting caught

Uncategorized

All day on the Alpine springs.

Everything disconnected from the axle and it was still locked in position on top of the springs. All u bolts removed and still nothing doing.

I jacked the car up in several places then decided the only way to free it was to hit it. So I did and they came away – with a bang – but both came down safely.

Picked up the post and found this to cheer me up. I was caught in a box junction and got £130 fine.

Went back t the garage a bit deflated but cheered up when I managed to get one spring off after another 2 hours.

Then all but the last bolt came away from number 2. However, no way to move it as it was locked in the rubber bush – so all I can do is cut it off now.

One hour later and I’d made it a bit smaller – it’s going to be a long job- and one for tomorrow.

Last thing a run to town in the Mk7.

Ladders and rusty bolts

Uncategorized

Thought I would loosen the bolts holding the leaf springs on the car – to make it easier to remove when the time comes. So I sprayed WD40 on them after using a wire brush to remove most of the surface rust. I let it soak for the morning.

Then SAAB loaded with ladders to Oli’s and twice into town and back.

Afternoon I could not resist seeing if the bolts would budge – which they did so I jacked the car up more and undid them half way. No movement from the car at all – everything is rusted solid…

Then final SAAB journey in the late afternoon. Lights definitely much better.

Looks great

Uncategorized

SAAB came home with cleaned headlights – looks great but I’ll see how long it lasts.

Also needed new brake pipes and other work so looking at a big bill.

Checked on the e-type and it will be another month at least.

Then I took the Alpine petrol tank in for repair/rebuild/refurbishment.

Better get back to work to pay for it all.

Tanking it

Uncategorized

OK – I decided to get the petrol tank out of the Alpine.

Started by jacking it up on the ramps – which went ok even though I had to reverse up. Two trolley jacks helped, but I can improve the system.

Next was the tank – which came out as planned too.

I stopped there, but I’m now thinking I should take the leaf spring off next while the car is on the ramps. The only issue is that it’s a bit high off the ground now ?
Treated myself to a run in the Caterham that had say patiently outside in the cold all day. Tank sneaked in to the picture too.