More screen time

Uncategorized

Spent the day building the Konstruktor camera and playing with photos of the E-type from last night.

Then Aero into town to get the film developed – the only problem was that the road had cars parked on both sides so I was inches away from each car.

Also thought the Aero needed a picture taken – did this while experimenting with my remote flash.

Lighting up again

Uncategorized

Took advantage of the ‘easy to use bubble’ today and strapped it up to look at the faulty lights on the Caterham.

No loose wires, but a fuse had tripped – could have been when I kicked the switch as I got out ? Also noticed the actual light switch is a bit dodgy so that might have tripped it. Little bugger. Can you tell which one ? No you can’t unless you press them back in.

Also checked the water while the bonnet (and then the nose cone) was off as it’s been running a bit hotter than normal. I’m glad I did as it took nearly 2l of water.

Went for a drive in the sun and the lights were still OK so that’s good for now.

Then decided it was ok to get the e-type out. Had to correct the over inflated tyres used for storage so checked what they should be. Seems I might have had them too high for a while. Reduced then and the car ‘felt’ better – perhaps…

Then night shooting again – I’d expected a few comments but not the army of camera phones and comments. Thank god I’m not famous too.

By the way that’s me in shot by accident – trying to light the bonnet up.

Seven hours with a Seven

Uncategorized

Spent most of the day playing with the Caterham as the sun was out and not too cold.

First I extracted it from the bubble which was its usual pain. Then went for a drive to the coast for lunch again – Felixstowe beach. Chatted to a few passers by about the car as I eat my sandwich in the blustery sunshine.

Then returned and looked at the deflated sack on the ground in preparation to putting the car away. There were two small holes in the outer lining at the front which I was able to feed a strop through and hang up. Then I spotted two more in the rear – again strop through. I needed to put up hooks and sew the ends together for a loop to use – so out came the 1960’s sewing machine.

That did the trick. The final strop in the middle just passes below the whole cover. So now I can put it up/down and drive under it at last.
Felt so energised I washed the car and took it to Ipswich the marina for pictures – in the spot I like. Took a few pictures and chatted to the usual random selection of passers by, some liking the car and some more interested in the photography.
They salted the road as I stood there as it was getting cold but I drove home quite warm in all my layers.
Final elation tempered by the failure of the dipped beam as I parked up – I’ve solved that problem before though so hopefully I can do it again.

Stepping backwards again

Uncategorized

Looked at the Alpine fuel pump to re-build it with the kit I got.

The vales seemed to be set in with metal lugs – so I left them alone.

Took off the new one to see if that was the same – it was. The diaphragm and seal were fine. It was full of rust in the bottom of the bowl, but not the filter. So I cleaned it out and put it back on.

The got the lug the wrong side of the arm that ‘pumps’ – again and again and again and again – so it took four goes to get it in the right place. I used a bit of string to keep the pump leaver up and over the cam as I fitted it.

Bowl filled up fine once in the right place.

Added an electric fuel pump to raise the pressure – made no difference. There is enough fuel in the carbs – they are very wet (and sooty) so what it is running it’s very rich.

Car won’t start again.

Sunshine – just

Uncategorized

Golf Mk2 to town – seemed to have the handbrake on all the time – although the last car I drove was the Aston…

Then Aero into town, traffic so bad I had to turn around and cross the bridge twice. Just a set of roadworks clogging it up.

Final night time run again in the warm SAAB.